Marvel G400 on a Celeron 333 running NT4

[jrr]

I want to put a Marvel G400 in a machine at work and wanted to check if it will be OK.

What version drivers & video tools should I be running under NT4?

I need to be able to just capture short clips, trim and compress to MPEG.

Regards

James

[Dr Mordrid]

The latest NT4 drivers for the Marvels are on this page;

http://www.matrox.com/mga/drivers/la...ivers/home.htm

The Celeron 333 is at the low end of the recommended processor speed range though. The lowest recommended is 300 mhz. That said is should work fine if the drives are decent.

Dr. Mordrid