Tweet
MsPRO6 and NT4 (sp5)
Dr Mordrid (or others),
I cannot get Mspro6 (veditor)module to run on my P3450(Asus/p2b-f,AGP board) with 256Ram, 12gH/D and Marvelg400 card. Every time I start this module it gives a dr watson exception access violation error.
I had Mspro5.2 installed and it had no problems.
My Mspro6 was a clean install by reformating and re-installing all software from scratch.
The other Mspro6 modules work fine - just not the veditor.exe file (I have also installed the latest Matrox/PC-VCR drivers and the Mspro6 patch).
Any suggestions would be most welcome.
You have mentioned in a previous post that the .ini file needs some tweaking???
What are the settings required for this and for optimal operation for SVideo/Pal capture from a digital CAMcorder and then print back to either the CAM or videoplayer??
Rob RW
I cannot get Mspro6 (veditor)module to run on my P3450(Asus/p2b-f,AGP board) with 256Ram, 12gH/D and Marvelg400 card. Every time I start this module it gives a dr watson exception access violation error.
I had Mspro5.2 installed and it had no problems.
My Mspro6 was a clean install by reformating and re-installing all software from scratch.
The other Mspro6 modules work fine - just not the veditor.exe file (I have also installed the latest Matrox/PC-VCR drivers and the Mspro6 patch).
Any suggestions would be most welcome.
You have mentioned in a previous post that the .ini file needs some tweaking???
What are the settings required for this and for optimal operation for SVideo/Pal capture from a digital CAMcorder and then print back to either the CAM or videoplayer??
Rob RW