I was able to get the whole setup to post and run Final Reality at 125*6 with 1/2 cache so far...
here are some pictures...I hope this works...
There are copper spacers between the aluminum heat transfer plate and the cache chips.
The two little heatsinks within is kept in place with frag tape.
Next step: try to see how far this can go...
Green
[This message has been edited by Green (edited 05 May 2000).]
here are some pictures...I hope this works...
![](http://www.students.uiuc.edu/~barrymei/pictures/DSCN0775_2.jpg)
![](http://www.students.uiuc.edu/~barrymei/pictures/DSCN0778_2.jpg)
![](http://www.students.uiuc.edu/~barrymei/pictures/DSCN0789_2.jpg)
There are copper spacers between the aluminum heat transfer plate and the cache chips.
The two little heatsinks within is kept in place with frag tape.
Next step: try to see how far this can go...
Green
[This message has been edited by Green (edited 05 May 2000).]