Tweet
I am currently using the following config:Pentium III 500
Tekram P6PRO A+ motherboard (VIA chips)128 SD Ram
Matrox Mill G400 32Mb Single head6.4GB Quantum Hardisk
I've had the problem of the screen becoming grabbled and
unreadable after I installed the graphics card with the initial
driver (version 5.12) I found that when I enabled the AGP 2X
mode in my bios, my screen becomes unreadable in Windows
98. Then, I downloaded your newest driver (version 5.25), the
problem is solved. However, when I use WCPUID to check my
system status, I found that I am currently using AGP 1X mode.
That means the new driver automatically disabled my AGP 2X mode.
Why can't I use my G400 card in AGP 2X mode?
Is it because of my motherboard (VIA)?or is it because of the G400?
I would be grateful if anyone could give me some help...
my email address is: (pls reply to both addresses)cl608281@netvigator.com
c9004569@hkbu.edu.hk
Tekram P6PRO A+ motherboard (VIA chips)128 SD Ram
Matrox Mill G400 32Mb Single head6.4GB Quantum Hardisk
I've had the problem of the screen becoming grabbled and
unreadable after I installed the graphics card with the initial
driver (version 5.12) I found that when I enabled the AGP 2X
mode in my bios, my screen becomes unreadable in Windows
98. Then, I downloaded your newest driver (version 5.25), the
problem is solved. However, when I use WCPUID to check my
system status, I found that I am currently using AGP 1X mode.
That means the new driver automatically disabled my AGP 2X mode.
Why can't I use my G400 card in AGP 2X mode?
Is it because of my motherboard (VIA)?or is it because of the G400?
I would be grateful if anyone could give me some help...
my email address is: (pls reply to both addresses)cl608281@netvigator.com
c9004569@hkbu.edu.hk