anyone still have an illuminatorPro (or owner manual)?

[vladeemir]

does anyone still have an illuminatorPro
or know any archives that may contain
pertinent info to the old Matrox Illuminator-Pro (circa ~1994) ?

i'm trying to get this board up in a new pc but my manuals seem to have evaporated over
time.

i'd appreciate hearing about any memories of this product, however dim.

Particularly, if anyone knows what the pin-
out for J3 and J4 was ?

vladeemir in san rafael

[This_Idiot]

I guess that Haig is the only one that's likely to have info on this one. Let's hope he pops by sometime soon.

[This_Idiot]

Well Haig didn't happen by, but a bit of digging (courtesy of an anonymous source) tells me that you need to talk to the Tech Support boys in Matrox' Imaging department. I've checked the website at http://www.matrox.com/imaging/support/contact_tech.htm which proclaims that you must be a registered user etc in order to contact them. But I'd be prepared to bet that a nicely worded email stating your position would elicit a friendly response.

If you want, CC your email to Chris@matroxusers.com (me). If you don't get any joy in a few days then I can raise it through our official channels.

Good luck

Chris
(T_I)