Voltages for CU-Mine's?

[JoeDredd]

Anyone know aht the default volatage and Vcore voltage is for a Coppermine 500e, as i need to make sure my IwillSlocket2 is configured properly

[Maggi]

1.60 Volts for FC-PGA and 1.65 Volts for SECC2 (Slot-1) ...

[RoGuE]

Markus is correct, as usual

[JoeDredd]

Right

My pin setting on my I-Will Slocket are as follows, as suggested by the I-Will web page. Thanks RoGuE for the link

Jumper 6.7.8,9 covering jumper 1 & 2
Jumper 1,2,3 covering Jumper 2 & 3
Jumper 4 no jumper
Jumper 5 covering 2 & 3

is this right?

[Mark F]

JoeDredd
You are showing JP8 as 1-2 that is for a PPGA aka. Celeron!!!

for a Flip Chip JP8 should be pins 2-3

For an Intel JP9 1-2

You have the FSB setting as AUTO (JP6and7 pins 1-2)

Your VCore is shown as 1.65. You probably don't need that much. Try the default voltage of 1.60 first. Change JP1 to OFF. or use the AUTO setting if your MoBo is cabable of adjusting for CuMines. That would be JP1,2,3,4,and5 set to OFF. The documentation shows this as no CPU but it's wrong (or atleast incomplete). That's how I have mine set and VCore is set by the MoBO (but I can't adjusted VCore with my MoBo, oh well my be the next one, but it's stable at 133FSB with 1.6 Volts).

Mark F.

------------------
OH NO, my retractable cup holder swallowed a CD



[This message has been edited by Mark F (edited 08 February 2000).]

[Maggi]

Thx

[JoeDredd]

My pin settings are now

Jumper 6&7 1&2 covered
Jumper 8 2&3 covered
Jumper 9 1&2 covered
Jumper 1 off
Jumper 2&3 2&3 covered
Jumper 4 off
Jumper 5 2&3 covered

is this right?

My mobo sorts the vcore for me

[Mark F]

Yes
That is forceing 1.60 VCore on the IWill.
The rest is fine also.
You said your MoBO sorts the vcore for you, then you could leave jumpers 1 through 5 OFF.
But either should work!
Hope I didn't muddy the water, with too much extra info.

Let us know how it runs,
Mark F.

------------------
OH NO, my retractable cup holder swallowed a CD

[JoeDredd]

Thanks Everyone

I will let u know how it goes

Joe