Matrox Tweak Utility + PD 6.0 not working

[Surfwienix]

Matrox Tweak Utility + PD 6.0 not working

any one tried it???

------------------
>> Surfwienix <<
(German)

My System:

AMD K6-2/400 non-o/c
Epox MVP3C-M Super7 (VIA 4.22 + AGP v4.03)
128MB SDRAM(PC100)
Matrox Millennium G400 MAX
(PD 6.0 BETA + TGL 1.3 + DX 7a) AGP2x/256MB @IRQ11(not sharing) non-o/c
Terratec DMX Sound-System
6,4GB Maxtor HDD (UDMA33)
ASUS 50x-CDROM (UDMA33)
Realtek 8019 Ethernet (ISA)
Creatix HAM V.90 Modem
19" Monitor CTX-VL950T (95khz)
Windows 98SE

[Maggi]

yup ... was reported before ... only works with PD5.x

[RAB]

MGA Tweak will work a little bit, but probably not enough to matter. Using my G400 on a K6-3 450, my 3dMark2000 scores only went from 1785 not overclocked to 1805 before I started to get screen corruption.

RAB

[kjliew]

Just curious...

Will you get more 3DMark using Matrox Tweak instead??

[RAB]

When I last tried the Matrox utility I was using PD 5.41 and could only get about 1750. I wasn't using MGA Tweak then, so I can't say what it would have done. Now with PD 6.0 and your MGA Tweak I can get over 1800 for the first time. This is using only the system clock overclocked. I haven't tried fine tuning it yet. Regular G400, no fan.

My other machine also has a K6-3 450, but a G200. It is using PD 5.41 and only has 3dMark99 on it. There I could only get 2260 on 3dMark99 with either Matrox or Powerstrip. I was pleasantly surprised when I switched to MGA tweak and my scores are now as high as 2555.

RAB

[This message has been edited by RAB (edited 22 June 2000).]