If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I'm also looking for this. I need to be able to capture a Macrovision encoded source (legitimate reasons!!!) - but forgot that I would loose that possibility when I upgraded to Powerdesk 5.*
Anyone? I'd hate to downgrade (and I cannot seem to find old enough files anywhere
the problem was sighted first, when i
tried to capture a simpsons-episode i
lend on video.
this tape had the macrovision on it.
o.k. i thought. connected my copy-
protection-decoder and tried again, but
the matrox again gave out the error-message.
maybe it's not only the macrovision ??
i tried to decode the premiere signal
and it gave out the same error. but premiere
doesn't send out a macrovision signal.
strange !!
there must be a way :-(( if not, i think
i will sell this shit card and buy a better
one. it's unbelievable that i'm not allowed
to capture the stuff which i want to capture :-
Whether you agree with Macrovision or not (and I don't personally), the reasons why Matrox had to implement it are well documented, and have been discussed at length on this forum.
There were cracked drivers for earlier powerdesk/video tool releases (go see my links page to find out where), but I haven't heard of any updates recently.
Just because you don't agree with Macrovision doesn't make Matrox products "shit".
Comment