TV Monitor output

[mrpc]

Hey guys I forgot the setting to use to enable monitoring the video on the TV while recording. Can anyone help?

I see the image on the computer monitor and playback is fine on the TV- just no image during the capture on the TV.

Thanks,

Richard

------------------
Abit BH6; 300A@450; 128MB
FastTrack66 dual KA 18GB; Marvel 200; MX300

[This_Idiot]

There isn't an official way of doing this, but you can try setting HKEY_LOCAL_MACHINE\Software\Matrox\Vidpres\General

"Enable Output" = 1 (DWORD key)

It works for some people, not for others.

[mrpc]

Thanks, I'll give it a try!

Richard

[RealTime]

If the above does not work for you there is another way.
Enable tv-out then run pc-vcr in full screen.
This gives you a pretty good output( a little scrunched) to the TV during capture.

[This message has been edited by RealTime (edited 31 October 1999).]