Marvel G400 TV with NT 4 (SP 6a)

[Mav]

Hello

I hope this is the right forum...

I was reading an article on www.murc.ws about the Marvel G400 TV and it specified that the Marvel would run on Win95 or Win98. It did not mention Win NT...
On the driverpage on www.matrox.com, NT drivers for the Marvel is available.

Will the Marvel run on a NT 4 SP6a system ?

Regars

- Martin

[This_Idiot]

Hi Martin,

Yes, this is the right forum, welcome on board.

Most folk that have tried this have been using SP4, and there have been varying degrees of success. I think that getting the card running as a display/editing device isn't too difficult but capturing has been the main stumbling block. However, new NT videtools were released recently and I haven't seen many posts about NT since then.

You could try searching the forums for "NT" or "NT4" using the search facility which is above and to the right of the forum list