Tweet
Jumpy Picture and Sima SCC Issues...
This is a follow-up to a previous message I posted about a source appearing ok on the TV, but not during capture: http://forums.murc.ws/ubb/Forum2/HTML/005588.html
I got a Sima SCC from Electronics Mailbox on the suggestions from the previous thread and plugged everything in and started my video again... it still jerks!
I read over the manual and looked at all the fancy knobs, but didn't see anything that was meant for video sync (so I assume it does it automatically, which would make since).
If my video is still jumping, during capture, while still going through the Sima SCC am I just out of luck?
(keeping in mind, that the $140 I spent on the SCC is all I'm doing... I'm not going to buy another magical black box)
I'm very bumbed because I was hoping this would fix it (I even payed for overnight to get is ASAP). grrr
Nick
I got a Sima SCC from Electronics Mailbox on the suggestions from the previous thread and plugged everything in and started my video again... it still jerks!
I read over the manual and looked at all the fancy knobs, but didn't see anything that was meant for video sync (so I assume it does it automatically, which would make since).
If my video is still jumping, during capture, while still going through the Sima SCC am I just out of luck?
(keeping in mind, that the $140 I spent on the SCC is all I'm doing... I'm not going to buy another magical black box)
I'm very bumbed because I was hoping this would fix it (I even payed for overnight to get is ASAP). grrr
Nick