Tweet
win 2k and video tools help_ pretty please?
i installed beta_2kvt200e.exe & beta_w2k506.exe. everything installed ok, and i captured with avi_io. i played the clip back and it was like frames were missing or something, the frames merged together. i.e. instead of 12345, the frames seemed to be 1 then 5, but the two morphing together. there was also a little distortion at the top that i dont dont get while capturing with ME.
should i be using different vt or something?
p.s. on a bit of an off topic, where do you see the ide properties of the hard drives in 2k? i can only see 'enable write caching'. should i leave that on btw?
please help. everything else is going ok apart from the capture prob.
p.s. what drivers would best be used for 2k? should i try the new leaked drivers or not? i cant use the new drivers that come out in a week or whenever since they wont have hardware mjpeg support, i have plenty of hard disk space- 2x30 gb and a maxtor 80gb, but that runs out when you capture to yuy2 for 5 or 6 hours at max quality.
[This message has been edited by mrtj1 (edited 26 June 2001).]
should i be using different vt or something?
p.s. on a bit of an off topic, where do you see the ide properties of the hard drives in 2k? i can only see 'enable write caching'. should i leave that on btw?
please help. everything else is going ok apart from the capture prob.
p.s. what drivers would best be used for 2k? should i try the new leaked drivers or not? i cant use the new drivers that come out in a week or whenever since they wont have hardware mjpeg support, i have plenty of hard disk space- 2x30 gb and a maxtor 80gb, but that runs out when you capture to yuy2 for 5 or 6 hours at max quality.
[This message has been edited by mrtj1 (edited 26 June 2001).]