How do I remove the black areas on TV out?

[DVDMan]

Last week I bought a Pinnacle DC10+ (video editing card) and was I amazed.....

The output from the Pinnacle Card is so much better than from the Mystique G200. The only bad thing is that it can't output mpeg movies. So I still need the TV out from the Mystique.

The main problem with the MG200 is that the TV out doesn't use the whole screen and displays black areas around the picture.

This is unacceptable.

Is there a way of adjusting the position and size of picture on the TV out?

[Elie]

OK,
First why don't you install the latest drivers for your Marvel G200 card.
If you don't want to upgrade that's ok but see if you can check these setting out..

1-go into Power Desk settings
2-click on TV out and check the box "Show display on TV"
3-click on monitor settings
4-click on adjust the current display mode

Turn your TV on.
Now all you have to do is click on the arrows until everything is aligned properly.
Click ok and your in buisness hopefully

Please understand if you dont see any of the options I just specified, its because your running the older drivers.
The best thing to do is try the new drivers, if my above recommendation doesn't work then you can always go back (which I doubt you will )

Nothing to lose if your that desperate

Regards and good luck
Elie

[cods]

What about people who have to use VT121 to use the DVD addon?