Ok I'm thinking about upgrading my celeron 300a@464 to a P3-450, since the P3 prices are so cheap now and the new turboOGL has made it even more attractive then before. I don't have a clue to when my MAX will get here but I figure that if I get the P3-450 I'll have it sooner
. My question is this...I know the that the P3-450 O/c well and I would be excatic if I can get it to run at 560 mhz or what not. The only thing is that my current system can't run my celery at 502 for a worth of shit. I think i might mess with the voltage setttings to see if that will help before I make the P3 purhcase.
My other question is I have a promise UtlraDMA/66 controller waiting to go into the computer (along with a new 56K PCI modem..damnit that MAX is holding up everything!) and I was wondering if there was any issuses with the Card using non-standard FSB settings as I would be using on a over clocked P3. I know that I wouldn't have any with the Celeron since its only running at 103 mhz now.
Thanks
Scott
------------------
Celeron300A@464 abit BH6 mobo, Marvel G200, V2 SLI, 128MB RAM, 19inch Optiquest Monitor, SB live!
![](http://forums.murc.ws/ubb/smile.gif)
My other question is I have a promise UtlraDMA/66 controller waiting to go into the computer (along with a new 56K PCI modem..damnit that MAX is holding up everything!) and I was wondering if there was any issuses with the Card using non-standard FSB settings as I would be using on a over clocked P3. I know that I wouldn't have any with the Celeron since its only running at 103 mhz now.
Thanks
Scott
------------------
Celeron300A@464 abit BH6 mobo, Marvel G200, V2 SLI, 128MB RAM, 19inch Optiquest Monitor, SB live!
Comment