Tweet
Hibernation in Win Me-display problem
Hi
This post is in partial reference to this: http://forums.murc.ws/ubb/Forum3/HTML/002872.html
I finally managed to enable ‘Hibernate’ in Win Me by not installing the drivers for ‘Wave device for voice modem’ and then disabling it. Hibernate works well too but there’s one problem- Whenever my computer is put into hibernation and then started the next time, it loads up fine except that the display is shifted to the left by about ½ a cm. Changing the refresh rate doesn’t help. I remember that Arbymo had the same problem but it couldn’t be solved. Any suggestions would be greatly appreciated!!
Thanks
Ovi
System Config:
PIII- 450, Acorp i440zx M/B, 128 MB PC100 SDRAM,
Samsung 4.3 GB ATA33 HDD,
Matrox Millennium G200 (8 MB)
Creative Ensoniq Audio PCI 64 sound card
Samsung Samtron 55v monitor (15”)
Win Me with DirectX 8
PD 6.21.037
[This message has been edited by Ovi (edited 12 January 2001).]
This post is in partial reference to this: http://forums.murc.ws/ubb/Forum3/HTML/002872.html
I finally managed to enable ‘Hibernate’ in Win Me by not installing the drivers for ‘Wave device for voice modem’ and then disabling it. Hibernate works well too but there’s one problem- Whenever my computer is put into hibernation and then started the next time, it loads up fine except that the display is shifted to the left by about ½ a cm. Changing the refresh rate doesn’t help. I remember that Arbymo had the same problem but it couldn’t be solved. Any suggestions would be greatly appreciated!!
Thanks
Ovi
System Config:
PIII- 450, Acorp i440zx M/B, 128 MB PC100 SDRAM,
Samsung 4.3 GB ATA33 HDD,
Matrox Millennium G200 (8 MB)
Creative Ensoniq Audio PCI 64 sound card
Samsung Samtron 55v monitor (15”)
Win Me with DirectX 8
PD 6.21.037
[This message has been edited by Ovi (edited 12 January 2001).]
Comment