G400 and Abit BH6 caution

[Yozzer]

Just a word of caution installing the G400 into a BH6, (especially if a little excited like I was). On powering up all I got was a double beep, no video. Reseated 3 times, eventually reinstalled my G200, O.K.. Just about to curse my bad luck, (it was the last G400 16meg oem in the show), and rush back with it, when I decided to try once more. It appeared to sit in O.K., but then I noticed the 3rd unused socket clip on the memory slot moving, yes, it was stopping the board from fully seating, the G400 is a bit longer than the G200, hence no problems with the "old" board. Moving the clip into the upright position sorted evrything out, and now the G400 works great. Can anyone tell me where I may get the conversion connector to try it out on the TV?. Or perhaps the pin outs so I can make a lead.
Also which version of powerstrip should I use to overclock?. I used to use Matrox Overclock on the G20