G200 Marvel FEEDBACK

[Owen]

Problem:
If Line In is not muted, feedback sqeals through my speekers.
The Louder the volume control on the Line-In, the higher the frequence of the sqeal.

I just updated the Bios to 3.51 (2.3), installed the original drivers from the CD (4.16.020), and the feedback went away.

I then proceded to install w9x433m, and the feedback came back.

I have unitalled all the drivers, and re-installed 4.16.020, and I still get feedback. Infact, if I install a standard VGA driver I get feedback.

If the video tools are loaded, and I start the TV-Tuner, the feedback stops.... until I reboot again.

HELP!!!! PLEASE!! :-o

[Flangor]

Have you downloaded the latest Vid Tools from Matrox? It seems that the problem was corrected with that version. Also, if you start up the PC-VCR than shut it off the screeching should go away. Also try and put the Microphone at half or less.

------------------
Flangor StrongAxe
flangor@matroxusers.com

System specs: One bourbon, one scotch and one beer

[SockBoy]

Hey there!

I've had the exact same problem. But, the higher I turn the Line-In volume, the lower the tone, until it turns into a low rumble. And if it's not that, it's static. It goes away when I turn on PC-VCR, though. Annoying problem.