SS7 + G200 +OpenGL +Quake I + II

[PAIT]

Hello,

I'm using a DFI P5BV3+ mobo with an AMD
350@400 with a G200 and when I run the OpenGL version of Quake I or II then my system freezes within a short period (30 sec..)

Does anybody have the same problems and
if so are they fixable??

Thanx,

PAIT

[Joel]

Look in your motherboard's CMOS settings and see if you have the following two parameters or something simular:

Cache RD+CPU Wt Pipeline
Read Around Write

If you do try disabling them.

Joel

[Fat Tone]

Do you have the same problem in any D3D games, or is it only OpenGL?
I used to get lockups in all 3D apps after a few minutes, but they were fixed after obtaining all latest drivers (I think the VIA motherboard drivers were most significant) and doing a fresh install as per the procedure on Joel's web page.

Good Luck.

------------------
Cheers, Tony.

System: K6-2-400, 128MB PC100, PcChips M577, 16Mb G200 Millenium (5.13,2.3, TV-out), Seagate 8.6Gig, SB PCI128, P821 (ALi M3309) DVD decoder, WinTV/PCI Tuner, CL 2x DVD, 36x CDROM, LS-120, Logicode 56K modem, etc