I already posted my problem some days ago, but nobody dared to give me some suggestions ...
After finally recieving my MAX I moved my good´ol G200 into my second PC (Compaq Deskpro EP400C). There was a G100 in the Compaq wich I uninstalled (using the uninstaller).
After putting in the G200 I installed PD5.13.020 and managed to get it working.
At least it looked like it worked. 2d and D3D was without any problems. But when I tried to run ANY OpenGL-stuff I got a bluescreen (MemoryParity Error ... System Halted)
This is the Configuration:
Compaq Deskpro EP400C
Celeron 400 running on Compaq EX-Board
64 MB Memory
6,4 GB EIDE
G200 running PD5.13.020, latest BIOS no IRQ conflicts !
DEC 10/100Mbit Ethernet PCI
WIN98
DX6.1
Any ideas are highly appreciated ! Thx ...
Bjoern
After finally recieving my MAX I moved my good´ol G200 into my second PC (Compaq Deskpro EP400C). There was a G100 in the Compaq wich I uninstalled (using the uninstaller).
After putting in the G200 I installed PD5.13.020 and managed to get it working.
At least it looked like it worked. 2d and D3D was without any problems. But when I tried to run ANY OpenGL-stuff I got a bluescreen (MemoryParity Error ... System Halted)
This is the Configuration:
Compaq Deskpro EP400C
Celeron 400 running on Compaq EX-Board
64 MB Memory
6,4 GB EIDE
G200 running PD5.13.020, latest BIOS no IRQ conflicts !
DEC 10/100Mbit Ethernet PCI
WIN98
DX6.1
Any ideas are highly appreciated ! Thx ...
Bjoern
Comment