G400 and NT 4.0

[seanFerg]

Where do you get the drivers for NT 4.0? I have a G400 Dualhead and would like to have the DualHead feature to work in NT. But I can't seem to find any drivers on their website. Does anyone have any ideas? Also, does OpenGL work under NT?

Thanks

[Sir Hitech]

Sean:

The 4.12 driver for NT is in the CD inside "NT" directory. It's kind of tricky to install it for the first time. After you installed the driver, it will ask you to reboot. DON'T do it yet. First set the color depth and resolution first then reboot. If you dont set the resolution the first time..you will have to re-install the driver over and over again until you set it. Been there Done that!

For dual-display under NT.. just follow the manual. Its straight forward. Just ask when you have problem.

[seanFerg]

Well, I installed the drivers off of the CD. The problem is I cant get the multi monitor configured. I have a second monitor attached and everything. The drivers were installed though with no reference to dual head. Are there dual head nt drivers?

[RoGuE]

Multi-Monitor IS supported under NT4 using the drivers supplied on the CD. Been there done that and it works fine. I didn't have to set the card up more than once either.

------------------
aka Chris H

Abit BP6, Celeron 366@550MHz, 128MB PC100 RAM, G400 32MB DH, SBLive! Value, IBM 22GB ATA/66 HDD, and so on...

[KvHagedorn]

NT 4.0 doesn't have multi-monitor support. If you want to run both monitors, you're stuck with Win98. Sorry.

------------------
Kind Regards,

KvH