Problem w/MatroxG400 and Athlon 600MHz

[ParaKnowYa]

Which flasher and which bios are you talking about?

Current best solution for K7M is to get the newest flasher flash822 and the newest final bios 1008. Try them and let me know whether or not it works for you! =)

If it does not work once, reset the CMOS and try it again.

[CannyOne]

Hi Leighton,

The beeping you here just indicates that one of the settings in BIOS has a value that's not working. You need to go through and check what might have changed. It's probably on the Hardware Monitoring page. If something there has "N/A" instead of "Ignore" change it. The beeping won't stop till you save and exit. But when you've found it, the next time the system starts you won't have the "Alarm".

[leighton]

Paraknowya,
The flash is the latest one! Flash822 and 1008.bin. I'm not sure if the that bios version is already loaded because when I boot up there's a continous beep. So what I did is reset the RTC short the solder point together with the delete key. After doing it no beep. As I said I can't see the version number of the bios because it boot up very fast.

[ParaKnowYa]

O.K. just do the following:
Reflash the mobo with the 1008 bios when it boots up next time, go into the bios and set it to load setup defaults or similar. Reboot via reset, go into the bios and choose the Fastest settings. Reboot. Now reenter the bios and check whether or not there are options enabled or disabled you might need. Also, if it beeps, check for any virus protection enabled, the fans are correctly set in the bios and the voltage!