someone can help me?:(

[deed]

i've got a g400 card
it's G4+/MDH4A32G
I MAKE A MISTAKE£¬I change it's pin file to MAX and not
save the old one
so the card is working in(150/200)
but in some 3dgames the picture will wrong
i want to get the old pin
but i don't know how
even used the recover.zip(matrox tools)
nothing has changed
still is MAX
please help me
thanks a lot

[Novdid]

You can always try to cool the card better, and keep at Max speeds.

[Dr Mordrid]

Either write Matrox tech support or get someone else to send you a copy of the correct PINS for your board type.

Dr. Mordrid

[deed]

you said i should get a fan for my card?
and how about the RAM?
needs to cool?

[Technoid]

Site with pin files!!

Check this site out:
MatroX Files

It has archives with pins files for most Matrox cards....

Edit:

Seems like my memory is a bit old...

The site has pins files but ony up to MarwelG200

[rubank]

This is how to restore the chips clock to the original speed:

Boot to a real-mode DOS prompt, preferably from a clean sys floppy where you also have dos4gw.exe and progbios.exe

Run:

progbios -d >pins.txt

edit the values at row

65 1 to 126
66 1 to 63
75 1 to 126
76 1 to 63

save the changes and then
run:

progbios -i auto -s pins.txt


This gives you the default clockspeed.

If you don´t have dos4gw.exe and progbios.exe you can download them from matrox.



rubank

[deed]

thanks all
because i only remember the card sn
and the others all missing
so i don;t know whether the card pin is the same?(g400 dh?)
it's will Influence ?
and how to make the drives detect my g400 dh but not g400max?
thanks
by the way
my english is very poor
so )))))

[Kruzin]

A fan should be all you need.
Running at that speed, stock cooling is not enough.
Attach an old 486 or pentium fan to the cards heatsink.
The RAM doesn't need any aditional cooling.

[DuRaNgO]

you could always just use mgatweak to lower the speed slightly

[Wombat]

It may be the RAM that can't run that fast. Just keep that in mind.

[deed]

thanks all
i changed pin to the correct
and now my g400 dh card working the right clock and memory
speed
but the driver still g400 max dh
i don't know should i change some number in the pin
and make the driver detect the right card's ID?
thanks

[Kruzin]

G400 and G400MAX use the same exact drivers.
It doesn't matter if it's detected as a MAX or not, so I wouldn't worry about it...

[deed]

thanks Kruzin
by the way
someone tell me
the NO61,71,81 in the pin file is about the sgram cycle
and g400 is difference for g400max
really?
if it's truth
should i change them and which number this the correct?
thanks twice