GeForce Q3test settings-try them for yourself

[Ozymandis]

These settings will make q3 curvier, although I did not notice much of a difference in look or framerate.

seta r_lodCurveError "10000"
seta r_subdivisions "1"
seta r_lodbias "-2"

edit these lines in q3config, then tell me if you had a change in fps. Oh yeah, I have a p3-500.

[Frank]

Yes, the GForce benchmarks and descripton of those commands are at:
http://www.3dgpu.com/reviews/nvidiaddr.cfm

[tish beta2]

Reminds me of the Subdivide Metaform command in modeler. That too evens things out by adding vertexes with a 179 degree smoothing angle.

The first picture seems to be a snapshot of Q3 without the "high geometry" option, while the other one has it enabled, as far as I can tell...

[Micko]

I can't see any difference in Q3 with GeForce settings...hmmm...

about 2-5 frames less...hmmm...

Micko,

[tish beta2]

Set the geometry setting to low and run around a bit. Then enable the "G-Forke" settings. You should be experiencing the same as the snapshots at the site posted by Frank.