Tweet
open gl problem
I have G200 in one of my computers. However I cannot get Quake2 to play in open gl mode. It only plays in software mode. My card does not have an assigned irq. Could that be the problem or is there something else I am unaware of? I am using the 5.30 drivers.
-
-
yes assign IRQ would be a good idea (it is needed for busmastering). Make sure it is enabled in your bios and powerdesk.
Also make sure you have cleaned out you drivers before installing new ones.
(always a good idea)
I have been playing quake 2 with my g200 ever since the gl_wrapper came out. and have found every new driver to be an improvement. currently using 5.41 without a hitch.
64mb BH6 450 celery g200@212.
win 98 SE.
Comment