If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Anybody got a low latency autoexec.cfg for HL/CS they would like to share?I tried making one from tweak3d.net but i did something wrong and it trys to default back to software mode.
Thanks in advance
P3 450@504
Abit BH6
128mb pc100
G400 32mb sh oem
Mx300
Kenwood 42x True-X
Standard floppy
6.4 Seagate Ultra ata/66 HDD
8.4 Quantum Bigfoot TS(lol slave)
Altec Lansing ACS-48's
JBL Medis 2000's
Soho 10/100 PCI NIC
NEC MultiSync XV17+
Intellimouse Explorer
Depends on whether ur main cause of lag is video or connection related.
Assuming ur a 56k Modem user, this should improve your connection lag a bit...
(assuming u've already got ur connection set up right in Windows, that can yield far bigger improvements)
rate <connect speed in bps /10>
ie rate 4600 if u get a 46 kbps connect
pushlatency -180 (wont do anything to ping, but makes lag less noticeable)
MOST IMPORTANT
fps_modem 25 (if you leave this off you send data every frame, if you've got a fast comp this lags you horribly)
also try r_netgraph 1. If you get lots of yellow peaks in the graph you might want to decrease the fps_modem settings slightly.
If your getting mainly video lag I cant help you I'm afraid...
Take a look <A HREF="http://i.am/tfc/">here</a> for lots more console vars to mess about with, or d/l 1 of their scripts....
Comment