Tweet
mix'n'match
anybody know if it is possible to use the G400 drivers, dll/vxd etc from PD5.3 with the mgaqdesk from 4.2 or w.h.y.???
or should I expect smoke.....
arth
or should I expect smoke.....
arth
-
-
why would you want to do this? are you talking about older drivers or the 4.22 for NT? In either case this shoudl not work... not too sure why since I am not a programmer but still...
[This message has been edited by Zwisch (edited 30 October 1999).] -
If I'm not mistaking Matrox removed all virtual desktop features after the 4.26 drivers (I'm pretty sure those have the feature).
So if you are using a G400 you are out of luck. No 4.x drivers will work with that card.Comment
-
virt. desktop also removed from all certified driversabit kt7-raid athlon 1ghz quantum 20.4gb - 7200 + wd 200bb - 7200 rpm UDMA100-
g400 max-
256MB pc133 sdram - sblive value 3.0 - 4 Boston Acoustics A40's - 3com 3c905b-tx - cable access - winME
dx7.?- V3 steering wheel/pedals - MS sidewinder PRO
Kensiko (Netpointe) scrolling mouseComment
-
hello,
well, out of ignorance or w.h.y. I supposed that the virtual desktop feature was supplied by qdesk which fed data, or something, about it to the actual card 'drivers' - any of the 'complete' powerdesk installs I have examined do not have drivers for G400 except 5.xx which don't have virt desktop?
I have tried to install 4.51 (G200 drivers) but got a message about 'no matrox card installed'!!
what d'ya think?
arth
Comment
Comment