Tweet
Overclocking a Mill G400?
I've tried using the Matrox Tweak Utility but it does not work... any other suggestions out there?
-
-
What OS? Also this thread should be in MGA Tools or Matrox Hardware, but tis OK
Also do a search on this topic... it has been majorly discussed many times"Be who you are and say what you feel, because those who mind don't matter, and those who matter don't mind." -- Dr. Seuss
"Always do good. It will gratify some and astonish the rest." ~Mark Twain -
overclocking a Mill g400
Sorry about that... well the operating System is Win98seComment
-
What drivers are you running?... the latest Matrox MTST Utility should work, but there is also MGA Tools (both found on http://www.MatroxUsers.com home page) to do the job and PowerStrip 3 ( www.entechtaiwan.com ) and also permanently setting it in the BIOS ( http://grafi.ii.pw.edu.pl/gbm/matrox/ )Last edited by Greebe; 16 August 2001, 22:42."Be who you are and say what you feel, because those who mind don't matter, and those who matter don't mind." -- Dr. Seuss
"Always do good. It will gratify some and astonish the rest." ~Mark TwainComment
Comment