Tweet
Remember that the original release "diagram" from Matrox showed the Parhelia as having VIP connectors as well. Matrox excels at throwing good features away.
-
Gigabyte P35-DS3L with a Q6600, 2GB Kingston HyperX (after *3* bad pairs of Crucial Ballistix 1066), Galaxy 8800GT 512MB, SB X-Fi, some drives, and a Dell 2005fpw. Running WinXP. -
I was pointing out that is the plug that could probably be used on the G400. however here is a picture of a plug that MIGHT be usable on the Parhelia, however i dont think the pin arangement that goes into the board will match up with the holes on the board, but its a poor quality image. it was the 1st i was able to find on google
If you went to someplace like www.digikey.com or www.mouser.com you could probably find the exact port you need
Originally posted by Greebe
wrong connector Doug... it's for an Svid output not composite vid outLast edited by D0ug; 22 November 2002, 16:43.Comment
-
so what you are saying is that the signals are actually running to the soldering points but they just did not solder one of those 50c cheapo connectors on it?
no matrox, no matroxusers.Comment
-
From what i read in a post in these forums a few months back, yes for the g400. i dont know about the parhelia.
I just found the topic its under
Originally posted by thop
so what you are saying is that the signals are actually running to the soldering points but they just did not solder one of those 50c cheapo connectors on it?
Comment
-
It goes alot deeper than that thop. The drivers must be made so it's enabled and supported properly for it all to work."Be who you are and say what you feel, because those who mind don't matter, and those who matter don't mind." -- Dr. Seuss
"Always do good. It will gratify some and astonish the rest." ~Mark TwainComment
-
is there a date for your NDA to be lifted?Comment
-
It's probably 24 hours after your pulse stops
______________________________
Nothing is impossible, some things are just unlikely.Comment
Comment