Hello,
I'm in need of some help to get Quake II to work in OpenGL mode with my G200 and PD 5.13.
When I try and change Quake II to Default Open GL mode it comes back and tells me there is no hardware acceleration and it goes back to the console.
I have an 8MB SGRAM Millenium G200 AGP.
I'm running Win98 at 1280x1024@24Bit Colour Depth.
I've also tried dropping the resolution down to 640x480 and trying it but no luck.
The strange thing is thhat I have had it working before I had to rebuild my system. Is there and order that you have to load the software in?
i.e PD drivers then DX6 and then Quake II?
Please e-mail me with any help as I do not check these forums that often.
Thanks & Regards
Grant
Taylorg@msn.com
I'm in need of some help to get Quake II to work in OpenGL mode with my G200 and PD 5.13.
When I try and change Quake II to Default Open GL mode it comes back and tells me there is no hardware acceleration and it goes back to the console.
I have an 8MB SGRAM Millenium G200 AGP.
I'm running Win98 at 1280x1024@24Bit Colour Depth.
I've also tried dropping the resolution down to 640x480 and trying it but no luck.
The strange thing is thhat I have had it working before I had to rebuild my system. Is there and order that you have to load the software in?
i.e PD drivers then DX6 and then Quake II?
Please e-mail me with any help as I do not check these forums that often.
Thanks & Regards
Grant
Taylorg@msn.com
Comment