If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
System 1:
AMD 1.4 AYJHA-Y factory unlocked @ 1656 with Thermalright SK6 and 7k Delta fan
Epox 8K7A
2x256mb Micron pc-2100 DDR
an AGP port all warmed up and ready to be stuffed full of Parhelia II+
SBLIVE 5.1
Maxtor 40g 7,200 @ ATA-100
IBM 40GB 7,200 @ ATA-100
Pinnacle DV Plus firewire
3Com Hardware Modem
Teac 20/10/40 burner
Antec 350w power supply in a Colorcase 303usb Stainless
we could actually save matrox a whole lot of cash here what with dogbert doing press releases voluntarily and damien on product design we could form a vuluntary pr and marketing team and save them a packet. in exchange for some information of course.
is a flower best picked in it's prime or greater withered away by time?
Talk about a dream, try to make it real.
one problem with that board whichmakes it fatally flawed. there is no way u could actually fit 3 cables on it as there is not room for them to connect. they would obstruct one another.
looks nice though
is a flower best picked in it's prime or greater withered away by time?
Talk about a dream, try to make it real.
The german magazine CHIP has reported that because matrox have canceled CEBIT they will have nothing of worth to offer in the 3D relm for a long time . I suppose they don't know about matrox going to E3 with the G550.
Comment